UP3/E 12/24V Variable Speed Electronic Fresh Water Pump 15 Litres per Minute

The innovative flange which isolates the motor housing from the pump gears is an industry first. This clever piece of product design has extended the life expectancy of the Marco pump range, removing the possibility of pump failure caused by condensation build-up in the motor housing. When the pump runs, heat is generated by the spinning motor. Cool water passing through the pump head then adds the conflicting temperature, causing condensation to build. Marco's new flange design allows this condensation to escape the motor housing.

Sealed and dry motor for extended life of the brushes and lower power consumption

Enhanced motor protection

Best performance in extreme hot and cold environments

Highly extended range of fluid temperature tolerance

Thermal and mechanical decoupling for reduced wear and extended seal life

Improved resistance to chemicals

Locked alignment of the pump head 

The PEEK gears guarantee constant pressure, heavy duty cycles, lower noise levels and excellent resistance to chemicals. The pump also features a nickel plated brass body and connections, stainless steel shaft, FKM seals and NBR O-rings. The pump is built to last and perform to the highest standard.

Constant control of pressure, voltage and electrical draw

Protection of the pump from short circuits and overvoltage

Automatic stop when no more liquid is present

Reduction in electrical interferences thanks to the gradual acceleration of the motor

Noise reduction during operation

Optimisation of electrical draw

Reduced wear of components and increased life span of the system

Operative functions signaled by LEDs

*Expansion tank can be ommitted from the circuit as the pump quickly responds to pressure change. TIMAGE reccomends the use of an expansion/accumulator tank in larger plumbing circuits or circuits with washer dryers fitted. Please consult the TIMAGE technical team with any queries: technical@timage.co.uk 

The PCS control panel is an optional accessory to the UP3/E pump. Connecting to the pump using the network cable, the panel can be used to remotely monitor the operation of the pump and interact with it.

The PCS panel can check liquid presence and reset the pump in case of malfunction without disconnecting the device.

The “Run” LED indicates that the pump is working and alerts in case of small leaks
in the system, preventing motor damage due to prolonged operation at low speed.

Stop and Start of the pump with a simple push of a button.

Quick connection of the panel to the 3m RJ11/6 terminal cable integrated in the sensor of the pump.

The panel can be recessed in a circular hole of a 70mm diameter or externally
mounted.

The terminal block allows the user to replicate the buttons and leds of the panel
on an external circuit thus favoring a personalized management of the functions
through an external device designed by third parties.